Slurry casting installation ULSh-3
Slurry casting installation ULSh-3 is used to produce ceramic ware from steatite, aluminum oxide, ferrite and other slurries by high-pressure die-casting.
The installation can be used to produce plates, rings, bushes, disks etc.
Specifications of slurry casting installation ULSh-3
Dimensions, LxWxH, mm |
740 х 440 х 1400 |
Weight, kg |
110 |
Power consumption, kW |
1,6 |
Volume of easily removable slurry tank, l |
3 |
Slurry working temperature, °C |
30...100 |
Die-mold plate working temperature, °C |
30...70 |
Slurry tank mixer rotation speed, rpm |
53 |
Ultimate vacuum in the slurry tank from the built-in vacuum pump in the degassing mode, mbar (not less than) |
5 |
Die mold closing force during filling with slurry, kgs |
600 |
Stroke of the closing pneumatic cylinder, mm |
50 |
Maximum dimensions of molded items, LxWxH, mm. Minimum dimensions of molded items are not regulated. |
150 х 150 х 150 |
The installation can be used both off-line and as a part of a production line |
|
The installation is produced in a moderately cold climate modification category 4.2 according to GOST 15150-69 and is intended for normal environmental conditions established in GOST 15150-69 |
|
The installation is powered by a three-phase AC network 380/220V, 50 Hz |
|
The installation requires: - compressed air supply at pressures from 4х105 to 6х105 Pa (from 4 to 6 kgs/sm2) and air consumption 1 m3/hour, - water supply at pressures from 1,5х105 to 2,5х105 Pa (from 1.5 to 2.5 kgs/sm2) and temperatures not higher than 25 °C, water consumption 200 l/hour |
|
On request of the Customer the installation can be equipped with additional slurry tanks